supported_hardware:barix
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
supported_hardware:barix [2019/01/10 19:41] – James Sentman | supported_hardware:barix [2023/02/13 14:52] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | =====Barix Barionet===== | ||
{{: | {{: | ||
Line 78: | Line 78: | ||
If you don’t already have units in the XTension database for all your inputs and outputs found on your Barix they will be created at this time. If you don’t wish to have units in the database for inputs or outputs that you’re not currently using you can delete these and then uncheck the “create units in XTension” checkbox in the Edit Interface dialog. | If you don’t already have units in the XTension database for all your inputs and outputs found on your Barix they will be created at this time. If you don’t wish to have units in the database for inputs or outputs that you’re not currently using you can delete these and then uncheck the “create units in XTension” checkbox in the Edit Interface dialog. | ||
+ | |||
+ | |||
+ | ====Other Verbs Supported==== | ||
+ | ===Query=== | ||
+ | The [[dictionary: | ||
+ | |||
+ | In the case of a built in 1-wire temperature sensor the address is translated from the hardware address to the proper current internal register address so you can simply query the unit by name to receive a temperature update right now. | ||
+ | |||
+ | ===Send Data=== | ||
+ | The [[dictionary: | ||
+ | |||
+ | The command does not need to be terminated by a return as that will be added by the plugin before sending it to the device. | ||
Line 83: | Line 95: | ||
* The original barix plugin has been part of XTension since 2009 | * The original barix plugin has been part of XTension since 2009 | ||
* the New plugin using the new plugin architecture was added in XTension v9.4.14 on 12/23/2018 | * the New plugin using the new plugin architecture was added in XTension v9.4.14 on 12/23/2018 | ||
+ | * Support for temp sensors on the X8 expansion modules was added in v9.4.15 on 1/11/2019 | ||
supported_hardware/barix.1547149284.txt.gz · Last modified: 2023/02/13 14:51 (external edit)