kits:onewire
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| kits:onewire [2019/12/01 13:49] – [WiFi 1-Wire Host Kit] James Sentman | kits:onewire [2019/12/23 16:58] – [Power Requirements:] James Sentman | ||
|---|---|---|---|
| Line 34: | Line 34: | ||
| This is not a battery operated project, it requires a stable DC power source. | This is not a battery operated project, it requires a stable DC power source. | ||
| + | Some 5v power supplies that sag even a tiny amount may not be able to provide enough power to the device. I would recommend at least a 6v power supply though some 5v supplies do work. | ||
| ====Connecting 1-Wire sensors: | ====Connecting 1-Wire sensors: | ||
| Dallas 1-wire temperature sensors can be connected in either powered mode using the GND, 3.3v and 1-wire data pins, or in parasitic power mode using only 2 wires of 1-wire data and GND. All sensors connected must be either powered or in parasitic mode, the 2 cannot be mixed together. | Dallas 1-wire temperature sensors can be connected in either powered mode using the GND, 3.3v and 1-wire data pins, or in parasitic power mode using only 2 wires of 1-wire data and GND. All sensors connected must be either powered or in parasitic mode, the 2 cannot be mixed together. | ||
kits/onewire.txt · Last modified: 2023/02/13 14:52 by 127.0.0.1