Differences

This shows you the differences between two versions of the page.

--- kits:onewire [2019/12/01 13:47] – [WiFi 1-Wire Host Kit] added purchase button James Sentman
+++ kits:onewire [2019/12/01 13:49] – [WiFi 1-Wire Host Kit] James Sentman
@@ Line 25: / Line 25: @@
 </html>
+Please note before you purchase that this kit works directly with XTension. Please verify that you can use it with your Home Automation system of choice before purchasing. At the moment I am shipping only to US addresses. Please contact me directly for information on shipping to Europe or other countries.
+----
 ====Power Requirements:====
 The built in switching regulator means that you can power the device with virtually any power supply that delivers between 5 and 40VDC through a standard 3.5mm barrel jack. The Vin and GND of the power supply input are also brought out to the 4 pin removable header so in case a barrel jack power supply is not handy or you already have other power available at the install site you can use that. **NOTE:** with version 1 of the hardware there is no polarity reversal protection diode on the board. Please verify that Vin is connected to the positive output and that GND is connected to ground or the device may be damaged.