Differences

This shows you the differences between two versions of the page.

--- kits:pwm [2023/10/23 13:14] – [GPIO Ratings and Safe Usage:] James Sentman
+++ kits:pwm [2023/10/23 13:50] – added firmware reset info James Sentman
@@ Line 147: / Line 147: @@
 ===Normal Operation:===
 In normal operation with a valid XTension connection the LED will be dimly lit to indicate that everything is working properly. You can configure the brightness of the LED or even set it to 0 if you do not wish the LED to be lit all the time. This setting is available on the settings web page. If the wifi drops or the connection to XTension is lost the LED will change to the appropriate state to indicate that.
+=====
+====Firmware Reset:====
+There are 2 ways to reset the device to “factory” defaults. At any time the device is powered on and running, hold the setup button for 10 seconds. The status LED will begin to flash rapidly indicating that it is ready to reset. Release the button and the defaults will be reset and then the device will reboot into setup mode so you can reset the wifi information and other settings.
+If the devivce will not finish the boot process or continues to restart for some reason you can reset the settings during the startup sequence.
+After resetting the device wait for the startup animation to begin fading the status LED up and down. During this animation press and hold the setup button. Do not press the setup button during the actual power on phase as this will put the device into local firmware upload mode. If this happens press the reset key and try again.
+After the startup animation completes the device will check for the setup button and if it finds you’re holding it the LED will begin to flash rapidly. Hold the setup button for about 10 seconds until the LED stops flashing and turns on at full. Release the setup button as soon as the LED stops flashing. The device will reset to defaults and reboot into setup mode.